|
さかにゃ日記 Information(臨時連絡)：
現在臨時連絡はありません。 まぁ暇なときでかまわないので、 一度くらいは通常のInformationをご覧ください。
この日記中のamazon.co.jpへのリンクはアソシエイト・プログラムが適用されています。
最近さかにゃ日記経由でAmazonで発注していただいた商品リスト
ちと空いた時間があったので、 YukinoたんのFreeBSD5.0-DP1をふにふにいじる。 そのうちまとめるかな。オレのために。
_ とりあえず
今日はここまで。 kernelの再構築して、suspendが動作すること、復帰してくることを確認した。 無線LANカードも使えてる。
Copyright (c) 1992-2002 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD 5.0-DP1 #0: Fri Apr 19 00:46:33 JST 2002 osakana@yukino.chinmai.net:/usr/src/sys/i386/compile/YUKINO Preloaded elf kernel "/boot/kernel/kernel" at 0xc03cc000. Preloaded elf module "/boot/kernel/acpi.ko" at 0xc03cc0a8. Timecounter "i8254" frequency 1193182 Hz Timecounter "TSC" frequency 597299967 Hz CPU: Transmeta(tm) Crusoe(tm) Processor TM5600 (597.30-MHz 586-class CPU) Origin = "GenuineTMx86" Id = 0x543 real memory = 251592704 (245696K bytes) avail memory = 240652288 (235012K bytes) Using $PIR table, 10 entries at 0xc00fdf20 npx0: <math processor> on motherboard npx0: INT 16 interface acpi0: <PTLTD RSDT > on motherboard acpi0: power button is handled as a fixed feature programming model. ACPI timer looks BAD min = 2, max = 526, width = 525 ACPI timer looks BAD min = 2, max = 6, width = 5 ACPI timer looks BAD min = 2, max = 6, width = 5 ACPI timer looks BAD min = 2, max = 6, width = 5 ACPI timer looks BAD min = 2, max = 7, width = 6 ACPI timer looks BAD min = 2, max = 6, width = 5 ACPI timer looks BAD min = 2, max = 323, width = 322 ACPI timer looks BAD min = 2, max = 6, width = 5 ACPI timer looks BAD min = 2, max = 6, width = 5 ACPI timer looks BAD min = 2, max = 6, width = 5 Timecounter "ACPI-safe" frequency 3579545 Hz acpi_timer0: <32-bit timer at 3.579545MHz> port 0x8008-0x800b on acpi0 acpi_cpu0: <CPU> on acpi0 acpi_tz0: <thermal zone> on acpi0 acpi_button0: <Power Button> on acpi0 acpi_pcib0: <Host-PCI bridge> port 0xcf8-0xcff on acpi0 pci0: <PCI bus> on acpi_pcib0 pci0: <memory, RAM> at device 0.1 (no driver attached) pci0: <memory, RAM> at device 0.2 (no driver attached) pcm0: <Acer Labs M5451> port 0x1000-0x10ff mem 0xfc004000-0xfc004fff irq 10 at device 4.0 on pci0 isab0: <PCI-ISA bridge> at device 7.0 on pci0 isa0: <ISA bus> on isab0 pci0: <display, VGA> at device 9.0 (no driver attached) pcic0: <TI PCI-1420 PCI-CardBus Bridge> irq 5 at device 10.0 on pci0 pcic0: PCI Memory allocated: 0x44000000 pcic0: Polling mode pcic0: TI12XX PCI Config Reg: [ring enable][speaker enable][pwr save][FUNC pci int + CSC serial isa irq] pccard0: <PC Card bus (classic)> on pcic0 pcic1: <TI PCI-1420 PCI-CardBus Bridge> irq 4 at device 10.1 on pci0 pcic1: PCI Memory allocated: 0x44001000 pcic1: Polling mode pcic1: TI12XX PCI Config Reg: [ring enable][speaker enable][pwr save][FUNC pci int + CSC serial isa irq] pccard1: <PC Card bus (classic)> on pcic1 pci0: <serial bus, FireWire> at device 11.0 (no driver attached) rl0: <RealTek 8139 10/100BaseTX> port 0x1400-0x14ff mem 0xfc006800-0xfc0068ff irq 11 at device 12.0 on pci0 rl0: Realtek 8139B detected. Warning, this may be unstable in autoselect mode rl0: Ethernet address: 08:00:xx:xx:xx:xx miibus0: <MII bus> on rl0 rlphy0: <RealTek internal media interface> on miibus0 rlphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto atapci0: <AcerLabs Aladdin ATA66 controller> port 0x1800-0x180f,0-0x3,0-0x7,0x3f4-0x3f7,0x1f0-0x1ff at device 15.0 on pci0 ata0: at 0x1f0 irq 14 on atapci0 ata1: at 0x170 irq 15 on atapci0 pci0: <bridge, PCI-unknown> at device 17.0 (no driver attached) ohci0: <AcerLabs M5237 (Aladdin-V) USB controller> mem 0xd0000-0xd0fff irq 11 at device 20.0 on pci0 usb0: OHCI version 1.0, legacy support usb0: <AcerLabs M5237 (Aladdin-V) USB controller> on ohci0 usb0: USB revision 1.0 uhub0: AcerLabs OHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub0: 2 ports with 2 removable, self powered acpi_button1: <Sleep Button> on acpi0 acpi_acad0: <AC adapter> on acpi0 acpi_cmbat0: <Control method Battery> on acpi0 acpi_lid0: <Control Method Lid Switch> on acpi0 atkbdc0: <Keyboard controller (i8042)> port 0x64,0x60 irq 1 on acpi0 atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0 kbd0 at atkbd0 psm0: <PS/2 Mouse> irq 12 on atkbdc0 psm0: model Generic PS/2 mouse, device ID 0 acpi_ec0: <embedded controller> port 0x66,0x62 on acpi0 orm0: <Option ROMs> at iomem 0xd8000-0xdbfff,0xc0000-0xcbfff on isa0 vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 sc0: <System console> at flags 0x100 on isa0 sc0: VGA <16 virtual consoles, flags=0x300> pmtimer0 on isa0 sio0 at port 0x3f8-0x3ff flags 0x10 on isa0 sio0: type 8250 or not responding acpi_cpu: CPU throttling enabled, 8 steps from 100% to 12.5% system power profile changed to 'economy' ad0: 28615MB <IC25N030ATDA04-0> [58140/16/63] at ata0-master UDMA66 Mounting root from ufs:/dev/ad0s3a
|
|
||||||||||||||||||||||||||||||||||||||||||||||||||
![[TDS]](image/tds-banner.jpg){kind=small}